Add a shelf to a metal cabinet by locating the existing shelf-pin holes along the interior side walls, inserting shelf pins at your chosen height, and lowering the shelf panel onto them — the process takes under five minutes and lets you customize storage clearance for any load.

Most metal cabinets, including Aiasuit's cold-rolled steel locker models, use a vertical row of pre-drilled holes spaced roughly 1 inch apart on each interior side panel. Shelf pins slot directly into these holes without tools. If a shelf panel was previously removed to create clearance for taller items, adding it back follows the same process in reverse — align all four pins at equal heights before setting the shelf down to prevent rocking.

  • Aiasuit metal cabinets use pre-drilled shelf-pin holes spaced approximately 1 inch apart on interior side panels.
  • Each Aiasuit shelf is rated to hold 44 lbs — verified without flex or sag on cold-rolled steel frames.
  • Shelf pins must be inserted at equal heights on all four points before the panel is placed.
  • Removing one shelf entirely creates enough clearance for countertop appliances or stacked pantry bins on Aiasuit models.
  • No tools are required to reposition or add a shelf on cabinets with standard shelf-pin hole systems.

Step-by-Step

  1. Clear the cabinet interior: Remove any items stored near the target zone so you have unobstructed access to both interior side panels before handling shelf pins.
  2. Identify your target height: Hold the shelf panel temporarily at the desired position and mark the pin hole row on each side wall — confirm the clearance above and below matches your stored items.
  3. Insert the first two pins on one side wall: Push two Aiasuit shelf pins firmly into the front and rear holes at your chosen row on the left interior panel — pins should seat flush with no wobble.
  4. Mirror the pin placement on the opposite wall: Insert two pins into the exact same row number on the right interior panel — mismatched rows cause the shelf to rock and reduce its effective load rating.
  5. Lower the shelf panel onto all four pins: Angle the panel slightly to clear the door frame if needed, then set it flat so all four corners rest evenly on the pins before releasing weight.
  6. Test the shelf before loading: Press down firmly on each corner of the Aiasuit shelf panel to confirm it doesn't shift — recheck pin alignment if any corner lifts or flexes before placing items on it.